Skip to main content

Clone drives

Cloning – in the interface Drive duplication – copies complete disks or individual drives directly to another disk, which can then replace the original. Backup and restore happen in one step, without a backup file; the source drives remain unchanged, because O&O DiskImage reads them only.

File-based or forensic​

MethodUse
File-based cloningTransfers all recognized data from the source to the target. Fast, efficient and sufficient for most cases.
Forensic cloningCopies every sector of the source, whether used or not. Needed when the file system of the source is not supported, for data recovery, and whenever an exact bit-by-bit copy of all sectors is required. Considerably slower.

A clone needs more space than a backup, because it is not compressed; it cannot be compressed or encrypted, and there are no incremental or differential follow-up clones.

Duplicate a drive​

  1. Select Drive duplication in the quick access bar.
  2. Enable the checkbox of the drive or disk to duplicate.
  3. Under Copy options, set error handling, read method and drive locking if needed.
  4. Select the target drive with its checkbox.
  5. In the following dialog, optionally define under Additional options what happens after the duplication, for example a verification, a rescan or the automatic shutdown.
  6. Select Start.

The duplicated data can later be copied back to another drive in the same way.

The target drive is overwritten

The selected target drive is overwritten completely; all data on it is lost. Use dedicated external or new drives as targets.

Notes for system partitions: adjust the properties of the target to its intended use and pay attention to bootability and partition types. When a second disk is the target, O&O DiskImage changes the disk signature of the target, so that two disks with the same signature never run at the same time; see Disks and file systems. For a duplication to a computer with different hardware, enable M.I.R.; see Dissimilar hardware (M.I.R.).

Copy options​

Drive duplication > Copy options controls the copy process in detail; the same options are available for restores.

OptionMeaning
Advanced > Ignore faulty sectorsAbort on errors stops the copy at the first faulty sector. Continue and mark sector as empty continues and writes faulty sectors as empty sectors, so all readable data is transferred – useful for damaged disks and data recovery.
Advanced > Read process > Lock driveLocks the source drive during the copy: it is hidden from Explorer, cannot be written to, and programs accessing it are closed. Off by default, so you can keep working.
Read methodUsed sectors only (fast; the standard for intact file systems), Forensic (all sectors) or Direct forensic (direct access to the physical disk, bypassing the file system driver). See Backup types.
Advanced > Force write methodWrite to drive writes through the file system driver and is the default for used sectors and forensic; Write directly to disk bypasses the driver and is the default for direct forensic. Mandatory when encrypted drives are restored from a forensic backup.
Advanced > Explicitly overwrite unused sectors with 0Overwrites unused sectors of the target with zeros, so deleted data in empty areas cannot be recovered – even with professional recovery software. For copies that must meet data protection requirements.

If the source drive is not locked, O&O DiskImage buffers changes in a cache of limited size; the cache status shows how much is left. A full cache lets changes reach the target directly, and the copy can become inconsistent – stop write-intensive processes such as a defragmentation during the copy. The system partition cannot be locked.

Profiles​

Copy options can be saved and reused: under Copy options, choose the Current profile (Standard or User-defined), save the current settings with Save as..., and edit or delete profiles with Manage profiles. The defaults of the duplication dialog – whether non-cloneable drives are shown and what a double-click does – are set under Program settings > Cloning; see Program settings.

Next steps​