Skip to main content

Load drivers

If a device – a hard disk, a RAID array, an NVMe controller or a network adapter – is not detected in the recovery environment of the boot medium, its driver is missing. Drivers can be loaded right after the start of the medium in the O&O System Settings dialog on the Drivers tab.

Typically affected are RAID and AHCI controllers, NVMe SSD controllers, special network adapters, USB controllers of modern mainboards and storage controllers in external enclosures.

Load a driver​

  1. Open the Drivers tab of the O&O System Settings dialog. It lists the devices that Windows PE detected and the devices without a driver.
  2. Select the device for which a driver is to be loaded.
  3. Select Load.
  4. Select the driver – from a connected hard disk, a USB stick or the driver CD of the manufacturer. The boot CD can be removed from the drive to insert a driver CD.
  5. Select Open to install the driver. A message reports the result.

If Windows PE asks for a restart after a driver was loaded, decline it and continue – the prompt is irrelevant when booting from a medium.

Notes​

  • RAID systems need the correct "F6 driver" or the Windows PE driver of the RAID controller (for example Intel RST, AMD RAID or LSI/Avago/Broadcom MegaRAID).
  • NVMe SSDs need their driver with older PE versions, otherwise the SSD does not appear.
  • Encrypted drives (BitLocker, VeraCrypt and others) are only supported in Windows PE after they have been unlocked or when compatible drivers are present. BitLocker volumes must be unlocked with the recovery key before a backup or restore. See BitLocker.

Prepare drivers in advance​

Extra drivers are almost always needed on whitebox and server mainboards, on systems with hardware RAID, on notebooks with special I/O controllers, and wherever Windows PE cannot establish a network connection. To be ready for an emergency:

  • copy the storage, network and chipset drivers of the computer to a USB stick in advance,
  • store them in clearly labeled folders such as \Storage, \Network, \NVMe and \RAID,
  • keep the stick connected when the boot medium starts.

If a drive or a RAID array is missing, the cause is in most cases a missing RAID, AHCI or NVMe driver, or a changed BIOS setting such as the RAID/IDE/AHCI mode. Drivers can also be integrated into the medium when it is created; see Boot medium and O&O DiskImage ToGo.