Skip to main content

RecoveryPartition

The O&O DiskImage RecoveryPartition is a recovery environment installed next to Windows on the hard disk. It starts O&O DiskImage even when Windows no longer boots – without a separate boot medium, without preparation, and with direct access to the backups stored on the computer.

What it contains and when it helps​

The RecoveryPartition is a standalone startup environment based on Windows PE with all O&O DiskImage components, the tools for backup and restore, drivers for the hardware detection, and access to internal and external drives, the network and the backup files. Once activated, it adds an entry to the Windows Boot Manager: at the start, you choose between Start Windows and Start O&O DiskImage RecoveryPartition.

Use it when Windows no longer starts, system files are damaged, a faulty or incompatible driver was installed, the system partition was destroyed or overwritten, malware or an update rendered the system unusable, or a system or drive restore should run without a USB stick or DVD. In the recovery environment, almost all tools are available: restoring system images, drives, partitions, files and folders, cloning, analyzing and validating images, access to network drives and external media, deleting and adjusting partitions, removing or resetting faulty drivers, and preparing M.I.R. restores.

Backups stored locally are detected automatically, so full and incremental backups can be restored quickly without additional media.

note

The RecoveryPartition does not replace external backup media. If the disk fails or the hardware is defective, backups must exist on external media. Create a boot medium in addition to the RecoveryPartition. See Boot medium and O&O DiskImage ToGo.

Requirements​

  • At least 3 GB of free space; as the default backup path at least 10 % of the disk size, but no less than 25 GB.
  • At most three primary partitions on MBR disks.
  • No dynamic disks.

Create the RecoveryPartition​

  1. Select Recovery Medium on the start page.
  2. Choose Use existing partition or Create new partition.
  3. Select the disk and, if applicable, the partition to use.
  4. Optionally define the RecoveryPartition as the default backup path; Maximum size adjusts its size.
  5. Confirm with OK. The bootable image is generated.
  6. Afterwards, create a full backup or a 1-Click backup – ideally directly onto the RecoveryPartition.

Start the RecoveryPartition​

  • Hold the Shift key and select Restart in the Start menu.
  • Or open Settings > Update & Security > Recovery > Advanced startup > Restart now.
  • If Windows detects system problems itself, choose Advanced startup, then Troubleshoot > Advanced options > Startup Repair.

After the start, the RecoveryPartition is typically shown in O&O DiskImage with the last available drive letter, often Z:.

Update or remove the RecoveryPartition​

Under Recovery Medium:

  • Update creates a new boot image after an update of O&O DiskImage; the backups on the partition remain intact.
  • Delete removes the RecoveryPartition together with the backups stored on it and reactivates the Windows Recovery Environment.
warning

Delete the RecoveryPartition only through O&O DiskImage. Deleting it manually, for example in the Disk Management, can cause system problems.