Skip to main content

Restore drives

A drive restore writes the drives of an image back to a disk. O&O DiskImage detects the type of the backup and the required parameters itself; in most cases no setting has to be changed.

Restore a drive​

  1. Select Drive restoration on the start page.
  2. Under Select image, choose the backup. If the suggested entries are not the right ones, browse to the backup file (.omg, .vhd or .vhdx) and select Open.
  3. All drives contained in the image are listed. Enable the checkbox of each drive to restore.
  4. Select the target drive with its checkbox: an existing drive that is replaced, or a new target in unallocated space.
  5. Optionally open Restore options.
  6. Select Start drive restoration.
The target drive is overwritten

The selected target drive is overwritten completely. All data on it is lost and replaced by the data of the backup.

What a restore needs​

  • A backup that is spanned across several media needs all of these media.
  • A backup of changes needs the whole chain: the full backup, all preceding backups of changes and the backup with the desired state. See Backup of changes.
  • When an entire disk is restored to another disk sector by sector, the target must be at least as large as the original. A smaller target needs a file-based restore, see below.
  • The system partition and the entire system can only be restored from the boot medium or the RecoveryPartition. See Restore the entire system.
  • For a restore to another computer, see Dissimilar hardware (M.I.R.); for encrypted drives, see BitLocker.

Restore to a smaller disk​

A drive can be restored or duplicated to a smaller target disk file by file:

  1. Select the source, for example the system partition C:, and the smaller target disk.
  2. Confirm with Yes when O&O DiskImage asks whether the boot partitions should be transferred as well.
  3. O&O DiskImage recognizes that a sector-based 1:1 copy is not possible and offers Sector-based and File-based. Select File-based.
  4. Define the size of the target partition and start the restore. The boot partitions are transferred completely.

If the source disk has several partitions, repeat the steps for each one and select the remaining free space of the target disk as its destination. The file-based restore uses the Volume Shadow Copy Service of Windows; if it causes problems, run the restore from the boot medium.

Restore options​

Drive restoration > Restore options adapts the restore to your environment:

OptionMeaning
Security and data integrityChecks of the data, for example the validation of the backup before the restore.
Behavior on unreadable sectorsWhat happens when a sector cannot be read.
Actions after the restoreAutomatic actions once the restore is complete.
Advanced > Force write methodWrite to drive writes through the file system driver and is the default for used sectors and forensic backups; Write directly to disk bypasses the driver and is the default for direct forensic backups. Forcing the direct method is required for encrypted disks, for drives that were backed up forensically and whenever the file system driver has to be bypassed.
Advanced > Explicitly overwrite unused sectors with 0Overwrites the unused sectors of the target partition with zeros, so data remnants from before the restore cannot be recovered. Recommended for confidential data.

Like backup options, restore options can be saved as profiles: set the options, select Save as, enter a name and confirm; Manage profiles edits or deletes them, Current profile switches between Standard and Custom.

The defaults for new restores – validation before the restore and the double-click behavior in the drive list – are set under Program settings > Drive Restore. See Program settings.

Next steps​