Virtual drives
A backup mounted as a virtual drive is browsed in the running Windows like any other drive – the way to copy individual files from an image without restoring it. ISO files can be mounted in the same way. Mounting needs a special O&O DiskImage driver; if it is not installed yet, the program says so and installs it on request.
Mount a backup as a virtual drive
- Open the Tools tab and select Mount, or press Ctrl+M.
- Select the backup file (
.omg) that contains the drive. Read backup information shows the details of a backup if you are unsure. - All drives of the image are listed. Select the drive.
- Choose a free drive letter, for example G:.
- Select Mount drive. The virtual drive appears in Windows Explorer.
Copy files or folders from the drive, check or compare data, or browse the content. The mounted drive is read-only: nothing can be deleted, renamed or added inside the backup. Only the areas that the backup contains are accessible, updating the view can take a moment, and only backups that are available locally can be mounted – backups on network drives cannot.
Load whole disks
A backup also stores the layout of the disk: the partition table (MBR/GPT), extended boot sectors, the LDM database and other system areas. Enable loading disk loads this information too and presents the operating system with a virtual hard disk that reproduces the original layout – useful for recovering deleted or damaged data from a forensic backup.
Mounting a complete disk can fail to detect the partitions when the partition table is damaged or invalid, when an unsupported layout was used, when dynamic disks with spanned, striped, mirrored or RAID-5 volumes were backed up without all participating disks, or when the disk is encrypted.
Unmount a drive
- Open the Tools tab and select Unmount.
- Select the virtual drive and remove it with the corresponding button.
After a restart of Windows, mounted virtual drives are removed automatically.
Mount an ISO file
- Open the Tools tab and select Mount ISO file as drive.
- Select the ISO file (
.iso). - Select Mount ISO file, and choose a drive letter if needed.
- After a moment, the virtual drive appears in Windows Explorer. It is read-only.
To show the virtual CD/DVD drive in the drive list of O&O DiskImage too, enable Include CD and DVD drives under Program settings > General and Show non-backupable drives under View. The drive is removed automatically after a restart of Windows.
Limitations and notes
- Remote Desktop: in an RDP session, a new login may be needed before mounted drives are shown correctly.
- VHD/VHDX: when a VHD/VHDX file is mounted, Windows may report that the disk image could not be mounted or contains no recognizable partitions. The message can usually be ignored; the file is mounted correctly.
- Access denied: if files on the mounted drive cannot be opened, the cause is usually a different security ID (SID) – the files were created under another Windows installation or user account. If necessary, enable the Administrator account, which is disabled by default, and access the files with it; administrator rights allow far-reaching changes, so proceed carefully.
Mounting and unmounting can be scripted with /mount image and /unmount image; see Command line.